Linde E35 - Page 248

5
Service work
Electrical enclosure
e3871493
1
2
 Connect the chain over the cross beam of
the outer mast (1) and under the cross beam
of the inner mast (2).
 Lower the inner mast to the cha
in stop.
 Switch off the truck.
 Push the emergency off switch.
 Fold up the rubber mat at the
front of the
truck and remove the cover f
rom the power
module.
e3871513
 Check the heat sink
(see arrow) on the
power module for th
e traction motors for
contamination.
 If necessary, clean the heat sink with
compressed air and/or cold cleaning
solvent.
NOTE
If the contamination is very heavy, additional
covers must be removed in the control com-
partment. Contact your service partner.
238 Operating Instructions – 3888011701 EN – 12/2017