No. 99MBG518A
E- 8
PART E : 2 Method to Test One Point
2.3
Indenter and Test Force Settings
Set the indenter and test force.
1
Touch the [Test] tab of the "condition setup" tab block.
» The Test settings screen is displayed.
2
Set the indenter and test force.
1 Touch the [Scale] button on the "basic
operation" block.
» The Scale settings screen is displayed.
2 Select the material of the indenter to be
used from [Indent].
For details about scale, see
"2.1 Scale" (page G-13) in "PART G
Settings".
3 Select the test force.
For details about scale, see
"2.1 Scale" (page G-13) in "PART G
Settings".
To Next Page
Loading...
