Section 2 --- Driving & Safety
The Executive 2005
116
Peak Level Memory:
The CO detector has the capability to remember the level of Carbon Monoxide that activated the
alarm. Press the TEST/RESET button for less than one second and observe the visual and audible sig-
nals.
• One beep and a green flash indicate memory is clear.
• Two beeps and two red flashes indicate less than 100 ppm.
• Three beeps and three red flashes indicate less than 200 ppm.
• Four beeps and four red flashes indicate greater than 200 ppm.
NOTE:
Memory is erased when power is disconnected for 15 seconds.
Cleaning & Maintenance
Use a vacuum cleaner to remove dust or any other buildup on the detector. Do not wash. Wipe the
detector with a damp cloth and dry with a towel. Do not open the detector for cleaning. Do not paint
the detector. It is recommend that the Carbon Monoxide detector be replaced every 10 years.
The CO detector has NO user service parts. If there is a problem with the detector refer to an
authorized service center. DO NOT REMOVE POWER.
INSPECT:
Check the CO detector weekly and at the beginning and end of each trip.
To Next Page
Loading...
