Monaco Executive 2005 - Test Procedure

Appliances --- Section 4
The Executive 2005
199
Test Procedure
Before using the washer for the first time, after winter storage or a long period of non-use, conduct
a simple test procedure to verify that all the hardware and electronic components are functioning.
Wipe the interior and exterior of the washer-dryer with a damp cloth to remove dust that has accu-
mulated.
NOTE:
Perform this test before putting the washer-dryer in use for the first time or after the
winter months. This will clear the water lines and drum of winterization antifreeze.
Test Procedure Requirements:
• Make sure water lines are secure and water valves are open.
• Hook to city water or turn on the water pump.
• Hook to shore power or start the generator.
To Conduct the Test Procedure:
1. Set the selector knob to Reset.
2. Set the Dry Timer knob to 30 minutes. Push the On/Off button to On. Wait five seconds.
The Auto Dry light should be on and the Status light flashes fast then slow.
3. Set the selector knob to a wash cycle. Set Wash Temp knob to Warm. Water should flow
into washer and the drum should rotate both directions.
4. Set the selector knob to Reset. Wait five seconds.
5. Set the selector knob to Spin. Water should drain and the drum rotation should speed
up.
6. Set the selector knob to Reset. Wait five seconds.
7. Set the selector knob to Dry. Dryer fan should begin and the drum should rotate both
directions.
8. Set the selector knob to Reset. Wait five seconds.
9. Set the Dry Time knob to zero. The Auto Dry light should go off.
031017c
Automatic Washer & Vented Dryer