Section 10 --- Chassis Information
The Executive 2005
468
Retracting Leveling Jacks
Automatic Retract:
Prior to retracting the jacks, it is advisable to start the engine and build air pressure.
• Turn the ignition switch to ACC.
• Confirm that the parking brake is applied.
• Turn the jack control Power switch ON.
• Momentarily press the level switch to ALL.
• The red warning lamp will stop blinking and the "bong" alarm will silence when all jacks
are retracted.
INSPECTION:
Before moving the motorhome always perform a visual inspection to be sure that
all jacks have fully retracted. Remove any debris that may be on the jack pad.
Hydraulic pressure, in all jacks, is automatically released when the All Jacks Retract switch is
pressed. The jacks retract by the weight of motorhome and the retract springs on each jack. The bot-
tom green light will begin blinking and all jacks will retract. This operation is on a four-minute timer.
After four minutes, the green light will stop blinking and go out.
020185b
To Next Page
Loading...
