EasyManua.ls Logo

Monaco Executive 2005 - Countertops; Solid Surface

Default Icon
538 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Section 3 --- Exterior & Interior Care
The Executive 2005
150
COUNTERTOPS - Solid Surface
Guidelines to maintain the countertop surface:
Routine Care:
The motorhome solid surface countertops and sinks have a matte/satin finish. Soapy water or ammo-
nia-based cleaners will remove most dirt and stains from all tops and bowls. Individual techniques may
be used to remove different stains. Follow the recommendations below.
Cleaning the Countertops:
Most dirt and stains - Use soapy water or ammonia-based cleaner.
Water marks - Wipe with damp cloth and towel dry.
Difficult stains - Use soft scrub and a Grey Scotchbrite Pad.
Disinfecting - Occasionally wipe surface with diluted household
bleach (one part water and one part bleach).
Cleaning the Solid Surfaces Sink:
Occasionally clean by using Soft Scrub Liquid Cleanser and a Grey Scotchbrite pad. Scrub the sink,
rinse and towel dry.
Removing Cuts and Scratches:
Solid Surface countertops are completely renewable. Use the following instructions to remove
minor cuts and scratches.
• Sand with 180 grit sandpaper, followed by 320 grit, until the scratch is gone.
• Restore the finish using a Grey Scotchbrite pad. Never sand hard in one
small area. Feather out lightly to blend restoration.
Preventing Heat Damage:
Hot pans and heat-generating appliances, such as frying pans or crockpots, can damage the surface.
To prevent heat damage, always use a hot pad or a trivet with rubber feet to protect the surface.
Other Important Tips:
Avoid using strong chemicals on the Solid Surface such as paint removers or oven cleaners. If these
chemicals come in contact with the Solid Surface, quickly wash with water. Avoid contact with nail
polish or nail polish remover. If contact is made, quickly wash with water.
NOTE:
Do not cut directly on the solid surface. When pouring boiling water into the Solid
Surface sink, run cold water to prevent damage.

Table of Contents

Related product manuals