Equipment --- Section 5
The Executive 2005
215
Unlock codes should be personalized upon receiving the motorhome. Unlock codes have two cate-
gories: Master and Optional codes. Master code enables motorhome entry and auxiliary control.
Deleting, adding or changing of Optional codes are performed at the Master code level.
INFORMATION:
Consult the system owner's manual for further information.
• To lock: Shut the door. Enter one of the three lock codes to lock the entry door and bay
doors, if connected.
• To unlock: Enter Factory Default Master code or a three to eight digit personalized Unlock
code, if programmed.
Keyless Entry Code Programming
All motorhomes equipped with the keyless entry are shipped from the factory with default settings.
It is recommended the unlock code be personalized for security purposes.
To Program a Personal Number:
1. Located under the co-pilot cup holder is the
Programming Switch, identified by a small black but-
ton with 22-gauge wires connected: Yellow is power -
Black is ground.
2. Press the Programming Switch until four (4) rapid
beeps are audible.
3. To open the memory for accepting the personalized
Master Code, enter 1119 on the keypad at the entry door.
4. Enter the new 3 to 8 digit master unlock code within five seconds.
5. Wait five seconds for two (2) rapid beeps.
6. Test the new Unlock Code.
7. If the code was not accepted, repeat the procedure.
WARNING:
Ensure possession of entry door keys prior to testing new personal code.
NOTE:
These instructions are for motorhomes equipped with "keyless entry" only.
030907
To Next Page
Loading...
