Section 5 --- Equipment
The Executive 2005
222
To Retract the Bedroom Slide-out:
• Check for sufficient clearance inside the motorhome before retracting the Slide-out room.
• Clear the floor to ensure there are no objects that could result in floor or Slide-out damage
during retraction.
• Remove any debris from the top of the Slide-out room.
• Prior to retracting the Slide-out room, start the motorhome. Allow the air bags to fully
inflate to normal travel height.
• Retract the leveling system or prepare the air leveling system for travel prior to operat-
ing the Slide-out.
• Turn the ignition switch OFF. The Slide-out room will not operate with the engine run-
ning.
• Confirm the house batteries are fully charged.
• Interior house power must be on.
• Locate the control switch for the Slide-out, usually on the vanity cabinet.
• Ensure all people, pets and objects are clear of the Slide-out room path.
• Press and hold the switch in the IN position. The Slide-out room will move slowly in. The
motor will change tone when the Slide-out is fully retracted.
• Release the switch.
CAUTION:
Continuous operation of the Slide-out can drain the battery and damage the Slide-
out motor by overheating. Never move the motorhome without having the Slide-out
retracted.
Manual Override - Electric Bedroom Slide-out
If the Slide-out room does not respond from the switch, check that all the safety features are in
place.
• Ignition key is OFF.
• Interior house power is on.
• House batteries are fully charged.
If the Slide-out room will not operate after verifying safety features, it will be necessary to manual-
ly retract the Slide-out.
WARNING:
Do not work on the Slide-out system unless the battery is disconnected. Make sure
the floor is clean before retracting the Slide-out room.
To Next Page
Loading...
