Section 10 --- Chassis Information
The Executive 2005
470
Maintenance
Occasionally, when the jacks are fully extended, wipe away dirt from the jack rod to help lengthen
the life of the jacks. How often this should be done varies with jack usage. Dexron III
®
will serve as
a solvent, as well as a lubricant. Occasional oil or grease on the extended jack ram is normal and
aids in the lubrication of the seals.
Component Replacement Model JII-45S:
The system is designed for self-purging in the event any component of the hydraulic system has
been removed or repaired.
To Purge the System:
• Fully extend and retract each jack twice.
Calibration:
The transmitter module may require calibrating to obtain an accurate level indication. The cali-
bration procedure requires two persons for convenience and accuracy and should only be performed
by qualified service technicians.
Adding Fluid:
Indication of low fluid levels is the
bong alarm intermittently engaging when
turning corners, or the the pump whining or
gurgling. Use Dexron III
®
automatic
transmission fluid to fill the reservoir.
To Fill the Reservoir:
1. Turn the ignition switch to the ON position. Turn the jack control Power switch ON.
2. Extend any jack six inches from the fully retracted position. All other jacks remain fully
retracted.
3. Unscrew the reservoir cap from the top of the reservoir.
4. Open a window or the entry door so the bong alarm is audible from outside the
motorhome. Slowly fill the reservoir with fluid until the bong alarm stops.
5. Replace the reservoir cap.
6. To retract the extended jack, push the RETRACT button.
7. Turn the jack control Power switch OFF.
8. Turn OFF the ignition switch.
020027
To Next Page
Loading...
