Section 10 --- Chassis Information
The Executive 2005
442
Maintenance for the system entails adequate lubrication. Use only a hand operated grease gun
on the fittings. Grease fittings for the steering system are found on the both ends of the drag link (the
bar connecting the steering gear to the axle), and on the steering drive shaft located between the
steering wheel and steering gear. The correct wheel alignment promotes longer tire wear and ease
of handling while minimizing the strain on the steering system and the axle components. Use
NLGI #2 Lithium soap base lubricant for all steering linkage and brake components.
Alignment
Camber:
Camber, as shown, is vertical tilt of wheel as viewed from the front of the motorhome. This is
machined into the axle when manufactured and is not adjustable.
• “Positive” camber is an outward tilt of the wheel at the top.
• “Negative” camber is an inward tilt of the wheel at the top.
090267
To Next Page
Loading...
