Section 4 --- Appliances
The Executive 2005
200
10. The door will unlock in two minutes or less. The Status light flashes fast then slow. The
door should now open.
11. Push the On/Off button to Out (Off) position. The Status light should be off.
WARNING:
Do not wash or dry articles that have previously been cleaned, washed, soaked or spot-
ted with gasoline, dry cleaning solvents or other flammable or vaporous substances
that could ignite or explode. Do not add gasoline, dry cleaning solvents or other
flammable or explosive substances to the wash water.
CAUTION:
Do not use heat to dry articles containing foam rubber or similar textured, rubber-like
materials.
To begin a wash load:
• Sort and pre-treat clothes.
• Add the measured amount of detergent suggested by the package directions (maximum
two tablespoons).
• Load the laundry loosely into the washer. Close the washer door.
• Turn the Wash Temperature knob to the desired temperature setting.
• Choose the desired washing cycle option using the Selector knob.
• Load wash tray with detergent.
• Turn the power ON.
• After the cycle is complete, wait two minutes for the door lock to release before attempting
to open the door.
Washer-Dryer Maintenance
Occasionally wipe the exterior cabinet of the washer-dryer with a damp cloth or sponge. Wipe dry
with a soft cloth. Do not use polish on plastic trim. In areas of hard water, detergent can accumulate in
the drum. Obtain a packaged water softener. Add quantity as specified by the manufacturer directly to
the drum. Run the washer through a complete cycle using hot water. Repeat the process if necessary.
Remove hard water deposits using only cleaners labeled as washer safe. Wipe the inside of the washer-
dryer door with a soft cloth to remove moisture. Periodically apply a thin coat of paste wax to the inner
door, especially to the area that is immediately next to the door window. This will protect the door fin-
ish from laundry spills and discoloration.
To Next Page
Loading...
