Electrical Systems - House --- Section 8
The Executive 2005
349
INVERTER-SINE WAVE (Optional)
Use the inverter when shore power is not available and not using the generator as a secondary power
source. The inverter/charger has limited AC power output. It may be necessary to operate items in
sequence rather than everything at once. Exercise care when using the inverter as an AC power source.
Use the inverter sparingly as it quickly consumes house battery power.
When hooked to shore power, or operating from the generator, the inverter charges the house bat-
tery bank. The inverter will not automatically begin charging when hooked to shore power or operating
the generator. A charge mode must be selected. The amount of time to charge the batteries to a full
state of charge will vary with the depth of discharge when the charge cycle begins and any additional
DC loads, such as lights.
NOTE:
The inverter is programmed at optimum values from the factory. Changing program
values may adversely affect inverter performance.
To Turn ON the Inverter:
• Press the red button on the inverter remote until the cursor scrolls to On.
To Turn OFF the Inverter:
• Press the red button on the inverter remote until the cursor scrolls to Off.
To Begin Battery Charging:
• Hook to shore power or start the generator.
• Press the red button on the inverter remote until the cursor indicates either Chg or On.
NOTE:
This is not a substitute for the owner's manual for the inverter. The inverter is com-
prehensive with many variables. Not all the programming details are covered.
NOTE:
When hooked to shore power or operating the generator, press the red button to enter
a charge mode by selecting "On" or "Chg" in the main menu. Failure to enter either
mode will result in dead batteries.
To Next Page
Loading...
