Monaco Executive 2005 - Programming & Resetting

Section 8 --- Electrical Systems - House
The Executive 2005
352
Programming & Resetting
Green Button:
Press the green button to scroll the cursor. An underscore of the first letter indicates the selected
mode. Press the green button to enable the Automatic Generator Start program, start the generator or
begin Equalize Charge.
OFF - Turns off inverter control over any generator function.
AUTO - Enables the automatic generator start program.
ON - Overrides the automatic start program and starts the generator.
EQ - Starts an Equalize Charge to the house batteries on the next start
cycle of the automatic generator start. The equalize charge (EQ) feature applies a high-voltage
charge to the house batteries. The Equalize Charge voltage can exceed voltage operating limits of
engine, transmission or other sensitive electronic equipment resulting in extensive damage. The
EQ feature should only be enabled by qualified personnel. Before beginning an equalize
charge, consult the battery manufacturer to obtain information on performing an equalize charge.
W
ARNING:
An Equalize Charge uses a significantly higher than normal charge voltage. This volt-
age can damage sensitive electronic equipment. Several precautionary measures are
required when performing an Equalize Charge. Only qualified motorhome personnel
should enable this feature. Consult the battery manufacturer before beginning an
equalize charge cycle.
Inverter Reset:
The factory default settings in the inverter are set to optimum values for most situations. Slight
adjustments may be necessary depending on the amperage available from shore power, personal habits
and battery type. A comprehensive study should be done before making any changes to the program-
ming profile. If the programming was altered, it is easily reset to the factory default values.
To Reset the Inverter:
• Press the Menu Headings Down button on the remote until Trace Engineering heading
“3” displays.
• Using the Menu Item buttons, scroll down until “Press Reset Now For Default” displays
on the screen.
• Using the eraser end of a pencil or a pen, press the “Reset to Factory Default” button on
the remote.
NOTE:
The main switch on the inverter remains ON.