Section 4 --- Appliances
The Executive 2005
176
WATER DISPENSER - HOT
A compact tank, mounted under the sink, uses 120 Volt AC and draws 6.5 amps to electrically heat
water to the temperature of 190° F (88° C). A thermostat is installed to maintain the water temperature.
The hot water dispenser system is vented to prevent tank pressurization.
WARNING:
To minimize the possibility of fire DO NOT store flammable items such as rags, paper
or aerosol cans near the mounted tank. DO NOT store or use gasoline or other flam-
mable vapors and liquids in the vicinity of this unit.
WARNING:
DO NOT remove or alter the thermal safety fuse. If
the thermal fuse is open, contact an authorized serv-
ice center. To prevent electrical shock turn the
power switch OFF and disconnect the power cord
before removing the access cover to adjust or service
the thermostat.
Operation:
Turn the Insta Hot switch to the ON position. It
takes approximately 10 to 15 minutes for the water to
reach 190° F (88° C). Use caution: steam or hot
water may spurt from the faucet without turning it
on. After 10 to 15 minutes, turn the faucet on for about
20 seconds to release steam that may have built up in
the hot water tank. Allow the water in the tank to
reheat. Repeat this step one or two times. When a
steady stream is dispensed, the hot water is ready for
use. To shut off the system, turn the switch to the OFF
position.
040490c
To Next Page
Loading...
