EasyManua.ls Logo

Monaco Executive 2005 - Winterizing the Washer-Dryer

Default Icon
538 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Appliances --- Section 4
The Executive 2005
201
If water flow to the washer-dryer is reduced, the Hot
and Cold water inlet screens may be clogged. Remove
water pressure and undo water lines at the back of the
washer-dryer. Use tweezers or pliers to remove screens
from fittings. Clean and install screens and water lines.
Hook to city water or turn on the water pump. Check for
water leaks before using the washer-dryer.
NOTE:
Should the washer-dryer need removal for
service, care should be taken as the washer-
dryer weighs approximately 170 lbs. Proper
accommodations should be made to avoid
risk of injury or damage to the cabinetry.
Winterizing the Washer-Dryer
To Winterize the Washer Dryer with Air Pressure:
1. Hook an airline (regulated to 45 psi or less) to the water inlet of the motorhome.
2. Rotate Selector knob to a wash position with the Wash Temp setting on Warm. Press the
power button to On. Air pressure will clear the Hot and Cold water lines.
3. After water lines are clear, rotate Selector knob to Spin. Allow the pump to drain the drum.
4. Set Selector knob to Reset and Timer to zero. The door will unlock in two minutes or less.
Open door and pour in ¼ gallon of RV antifreeze.
5. Set Selector knob to Spin. The pump will prime with antifreeze. Set selector knob to Reset
and turn the power off.
To Winterize the Washer Dryer Using RV Antifreeze:
Two methods of introducing antifreeze to the water system can be used. Add antifreeze directly to
the water tank or use a separate container of antifreeze with water line hooked to the intake side of the
water pump.
1. Turn on the Water Pump. Rotate Selector knob to a wash position with the Wash Temp set-
ting on Warm. Press the power button to On. Allow antifreeze to enter the drum.
2. After water lines are filled with antifreeze, rotate Selector knob to Spin. Allow the pump to
drain the drum.
3. Set Selector knob to reset and Timer to zero. The door will unlock in two minutes or less.
Turn the power off.
4. Any remaining liquid should contain a sufficient amount of antifreeze to be protected from
freezing.
NOTE:
After winter, perform a Test Procedure before washing or drying any laundry to
make sure all antifreeze has purged.
0310176b
Water Screen

Table of Contents

Related product manuals