Equipment --- Section 5
The Executive 2005
211
ENTRY DOOR
The entry door incorporates three separate seals to eliminate wind noise during travel. The door
uses two separate locks for safety and security: the door handle and a dead bolt. The door handle incor-
porates a primary and secondary latching system used to ensure secure and safe latching. Adjustments
can be made to help maintain entry door performance.
Air Seal
The entry door is equipped with a one-piece air seal to reduce wind and road noise.
• The seal automatically inflates when the engine is running and the transmission shift selec-
tor is placed in Drive.
• The entry door seal will inflate to approximately 3 to 4 psi.
• The pressure regulator control valve is located behind the front cap on the left side of the
generator.
• When the transmission is placed in neutral, the entry door seal will deflate.
CAUTION:
If the pressure regulator should require adjustment, do not exceed 5 psi. Damage to
the seal may occur.
090419
Door Seal Regulator
To Next Page
Loading...
