- 10 -
Energy-saving of
idle door machine
After the car lamp is turned off, the system does not
output the door close command, which reduces power
consumption of the door machine.
Set in FE-14
4. Optional function list
Function Description Remarks
Door pre-open
In automatic running state, when the elevator speed is
smaller than 0.2 m/s at normal stop and the door zone
signal is active, the system shorts the door lock by
means of the shorting door lock circuit contactor and
outputs the door open signal, implementing door pre-
open. This improves the elevator use efciency.
Door pre-open
module MCTC-SCB
required
Micro-leveling
After landing at a oor, the elevator may move upward
or downward due to the load change and the car door
is not aligned with the ground, which is inconvenient for
in and out of passengers and goods. In this case, the
system allows the elevator to run to the leveling position
in the door open state at the leveling speed.
Door pre-open
module MCTC-SCB
required
Power failure
emergency
evacuation
For the elevator congured with UPS, the system uses
the UPS to implement low-speed self-rescue in the case
of power failure.
UPS required
Onsite
commissioning
The system can control and monitor running of elevators
by using the NEMS software.
NEMS software
required
Commissioning
by cell phone
The Android cell phone can be connected to the
controller through the external Bluetooth module, and
you can commission and monitor the elevator, and
upload and download parameters by using the cell
phone.
The software does not not supporting English version
currently.
Special Bluetooth
module (MCTC-
BTM-A) and cell
phone host EDSAP
required
Residential
monitoring
The control system can be connected to the terminal in
the monitoring room. By using the NEMS software, you
can view the oor position, running direction, and fault
state of the elevator.
NEMS, accessories,
and residential
monitoring board
MCTC-MIB required