4-88 Motorola RF Switch System Reference Guide
Information in black represents the statistics from the last 30 seconds and information in blue represents
statistics from the last hour. Use both sets of data to trend statistics in real time versus a measurable
period (1 hour).
4. Refer to the Information field for the following information:
5. Refer to the Traffic field for the following information:
6. Refer to the RF Status field for the following information:
7. Refer to the Errors field for the following information:
MAC Address Displays the Hardware or Media Access Control (MAC) address for the MU. This
address is hard-coded at the factory and cannot be modified.
BSS Address Displays the MU’s BSSID.
IP Address Displays the current IP address for the MU.
Voice Displays whether the MU is a voice capable device. Traffic from voice-enabled
MUs is handled differently (higher priority) than traffic from MUs without this
capability.
WLAN Displays the name of the WLAN the MU is currently associated with.
WMM Displays WMM usage status for the MU, including the access category currently
in use. Use this information to assess whether the MU is using the correct WMM
settings in relation to its intended data traffic type.
Pkts per second Displays the average packets per second received by the MU. The Rx column
displays the average packets per second received on the selected MU. The Tx
column displays the average packets per second sent on the selected MU.
Throughput Displays the average throughput in Mbps between the MU and the Access Port.
The Rx column displays the average throughput in Mbps for packets received on
the selected MU from the Access Port. The Tx column displays the average
throughput for packets sent on the selected MU from the Access Port.
Avg. Bit Speed Displays the average bit speed in Mbps on the selected MU. This includes all
packets sent and received.
% Non-unicast pkts Displays the percentage of the total packets for the MU that are non-unicast
packets. Non-unicast packets include broadcast and multicast packets.
Avg MU Signal Displays the RF signal strength in dBm for the selected MU.
Avg MU Noise Displays the RF noise for the selected MU.
Avg MU SNR Displays the Signal to Noise Ratio (SNR) for the selected MU. The Signal to Noise
Ratio is an indication of overall RF performance on the wireless network.
Avg Num of Retries Displays the average number of retries for the selected MU. Use this information
to assess potential performance issues.
To Next Page
Loading...
Need help?
General
