Parker Compax3 I10T10 - 4.4 Optimization

Setting up Compax3
C3I10T10
116
192-120100 N16 C3I10T10 - December 2010
4.4 Optimization
Optimization window
In this chapter you can read about:
...................................................................................................... 117
Scope ............................................................................................................................ 118
Load identification .......................................................................................................... 126
Control Loop Dynamics ................................................................................................. 129
Input simulation ............................................................................................................. 139
Setup mode ................................................................................................................... 141
Alignment of the analog inputs ....................................................................................... 142
Turning the motor holding brake on and off .................................................................... 143
 Select the entry "Optimization" in the tree.
 Open the optimization window by clicking on the "Optimization Tool" button.