Parker Compax3 I10T10 User Manual

Parker EME
Communication
192-120100 N16 C3I10T10 - December 2010
159
5.3 Remote diagnosis via Modem
Structure
In this chapter you can read about:
........................................................................................................................ 160
Configuration of local modem 1 ..................................................................................... 161
Configuration of remote modem 2 .................................................................................. 161
Recommendations for preparing the modem operation .................................................. 162
As the transmission via modem may be very slow and interference-prone, the
operation of the Compax3 ServoManager via modem connection is on your
own risk!
The function setup mode as well as the ROLL mode of the oscilloscope are
not available for remote diagnosis!
It is not recommended to use the logic analyzer in the Compax3 IEC61131-3
debugger due to the limited bandwidth.
Requirements:
For modem operation, a direct and stable telephone connection is required.
Operation via a company-internal telephone system is not recommended.
Caution!

Parker Compax3 I10T10 Specifications

General

Rated Current	10 A
Protection Class	IP20
Supply Voltage	200-480 VAC
Control Interface	EtherCAT, CANopen
Feedback Options	Resolver