Polaris 2012 RANGER RZR 570 INTL User Manual

7.5
FINAL DRIVE
7
9923523 - 2012 RANGER RZR 570 Service Manual
© Copyright 2011 Polaris Sales Inc.
5. Install front wheel hub assembly, cone washers, and
hand tighten th e ca stle nut. Insta ll washers with
domed side out.
6. Install b rake caliper mo unting bo lts a nd torque to
spec
ification.
7. Install the steering tie rod end onto the front bearing
carrier.
NOTE: Refer t o the photos below to ens ure proper
plac
ement of the tie rod end.
8. Torque the tie r od end fastener to spe cification and
i
nstall a new cotter pin.
9. Torque wh eel h ub n ut to spe cification and install a
ne
w cotter p in. Tigh ten n ut slightly if ne cessary to
align cotter pin holes.
10. Install wheel and (4) wheel nuts. Torque wheel nuts
to spec
ification.
11. Rotate wheel and check for smooth operation. Bend
b
oth en ds of cotte r pin around end of sp indle in
different directions.
= T
Front Caliper Mounting Bolts:
31-34 ft. lbs. (42-46 Nm)
CAUTION
New bolts have a pre-applied locking agent
which is destroyed upon removal. Always use
new brake caliper mounting bolts
upon assembly.
Out
Cone Washers
Wheel
Hub
42.5 ft. lbs.
58 (Nm)
Tie Rod End
= T
Tie Rod End Fastener:
42.5 ft. lbs. (58 Nm)
= T
Wheel Hub Castle Nut:
80 ft. lbs. (108 Nm)
= T
Wheel Nuts:
Steel Wheels: 27 ft. lbs. (37 Nm)
Aluminum Wheels: 30 ft. lbs. + 90° (1/4 turn)
80 ft. lbs.
NEW Cotter Pin
(108 Nm)

Polaris 2012 RANGER RZR 570 INTL Specifications

General

Brand	Polaris
Model	2012 RANGER RZR 570 INTL
Category	Offroad Vehicle
Language	English