Polaris 2012 RANGER RZR 570 INTL User Manual

3.19
ENGINE / COOLING SYSTEM
3
9923523 - 2012 RANGER RZR 570 Service Manual
© Copyright 2011 Polaris Sales Inc.
4. Remove the pressure cap (B) and add the necessary
amount of Polaris Premium Antifreeze to the radiator
filler neck.
5. Remove the cargo box access
cover to gain access
to th e coola nt bleed screw that is on top of the
thermostat housing.
6. Open the bleed screw (C) to allow any trapped air to
es
cape.
7. Fill the radiator until a steady stream of coolant begins
to drain out of the bleed screw (C).
8. Tighten the b leed scr ew to sp ecification, to p o ff
coo
lant and properly install the pressure cap.
9. Start the engine and allow it to idle until the coolant
fan has cycled.
10. Allow engine and cooling sys
tem to completely cool
down (see CAUTION).
11. Remove the pressure cap. Add the necessary amount
of P
olaris Premium Antifree ze to the radiator filler
neck.
12. Open th e ble ed scre w to allo w any tr apped air to
e
scape. Close the bleed screw once a steady stream
of coolant begins to drain out.
13. Tighten the b leed scr ew to
sp ecification, to p off
coolant and properly install the pressure cap.
14. Fill the recovery bottle to the MAX line.
15. Reinstall the hood.
16. Reinstall cargo box access cover.
= T
Coolant Bleed Screw:
6 ft. lbs. (8 Nm)
C
= T
Coolant Bleed Screw:
6 ft. lbs. (8 Nm)

Polaris 2012 RANGER RZR 570 INTL Specifications

General

Brand	Polaris
Model	2012 RANGER RZR 570 INTL
Category	Offroad Vehicle
Language	English