Princeton Instruments PI-MAX4 - 13.5 RF Modulator Specifications

Chapter 13 PI-MAX4: 1024i-RF and RF Modulation 215
13.5 RF Modulator Specifications
Modulation Frequency: 1 MHz – 200 MHz in 1 MHz increments.
Phase Modulation:
• Static phase: 0° – 359° in 1° increments
• Programmed sweeps covering >360°
User RF Output Voltage: 0.1 – 1.6 V
p-p
(in 0.01 V
p-p
increments)
Table 13-3: PI-MAX4: 1024i-RF Power Supply Connectors, Indicators, and Switches
# Item Description
1 Power Indicator LED turns bright green when power switch (item #5) is turned on.
2 Tec Fault Indicator LED turns bright red when a Temperature Control fault is detected.
3 PI-MAX4: 1024i-RF
Power
7-pin D connector. Connects to the PI-MAX4: 1024i-RF camera.
4 RF Module Power Power output for the RF modulation section of the camera.
5 AC Power Switch On/Off toggle switch for incoming AC power (via item #6.)
• O = Off
•
I = On
6 AC Power Input Connects the Power Supply to an external AC receptacle using a standard
AC cable.