Princeton Instruments PI-MAX4 - Lightfield Host Computer Requirements

Chapter 3 System Setup 37
3.4.3.2 LightField Host Computer Requirements
When running LightField data acquisition software, the host computer must meet, or
exceed, the following specifications:
• 64-bit Operating System
— Windows Vista
®
;
— Windows
®
7, 8.1, or 10.
• 2 GHz Pentium
®
4 (minimum)
• 1 GB RAM (minimum)
• CD-ROM drive
• At least one unused PCI card slot (32-bit) (PCI 2.3 compliant 32-bit 33/66 MHz
bus)
• Super VGA monitor and graphics card
Supporting at least 65535 colors with at least 128 Mbyte of memory.
NOTE:
Memory requirement is dependent on desired display
resolution.
• 10,000 RPM (recommended) hard disk with a minimum of 1 GB available space.
A complete LightField installation requires approximately 50 MB of space. The
remaining space is required for data storage, and is dependent on the number and
size of images/spectra collected.
NOTE:
Disk level compression programs are not recommended.
• Mouse or other pointing device.