Scalar i6000 Installation Guide 107
9 If you are installing FC I/O blades in the I/O management unit, proceed to Installing Blades in the I/O
Management Unit on page 108.
If you are not installing FC I/O blades, proceed to Applying Power
on page 93, and then follow one of
these paths:
• If you are going to directly attach either the FC or SCSI drives to a host, proceed to Attaching FC
and SCSI Drives Directly to Hosts on page 124.
• If you are connecting the FC drives to I/O blades, you will first follow the instructions in Installing
Blades in the I/O Management Unit on page 108 and then complete the procedure in Drive Cabling
Considerations and How Drive Connection Model Affects Library Control Paths on page 112.
Make sure you review the information in Cable Connection Requirements
for FC Drives on page 114 before connecting the cables.
To Next Page
Loading...
