182 Configuring the Library
Proceed to the appropriate steps.
Creating Partitions
The ability to create multiple partitions is controlled by licenses. See Enabling Licenses on page 163 if you
have not already configured your library’s licenses.
You can create partitions automatically or manually. If you choose to configure a partition manually, you can
allocate library resources to it using either Simple or Expert mode.
Creating Partitions Automatically
You can use the library’s automatic mode to create partitions within limits based on licensing restrictions
and available resources. Because automatic mode is available only if no partitions currently exist, you must
first delete the default partition that was initially configured on the initial boot-up.
1 Click Setup→ Partitions→ Configure.
The Partitions dialog box appears.
Setup > Device
> Access
Configuring Host Access
• FC Host LUN Mapping
on
page 204
• LUN Mapping Wizard
on
page 211
Step 4
Setup > Device
> Access >
SNW Host
Configuring the SNW Host
Device on page 218
Step 5
Table 7 Control Path Matrix
GUI Menu Path Procedure References
MCB Direct
Connection
FC I/O Blade
Connection
LTO-5
Connection
To Next Page
Loading...
