Quantum Scalar i6000 - Expansion Modules

Scalar i6000 Installation Guide 19
Installing a Stand-Alone Control Module
This chapter describes how to install a stand-alone control module. To install a new multi-module library or
add expansion modules to an existing control module or multi-module library, see Installing a Multi-Module
Library on page 27.
To install a stand-alone control module, complete the following procedures:
• Positioning the Stand-Alone Control Module
on page 20
• Lowering the Leveling Legs
on page 20
• Raising the Control Module Off the Casters
on page 21
• Testing the Digital Level
on page 22
• Verifying Level Condition
on page 23
• Additional Leveling
on page 24
• Setting the Leg Lock Nuts
on page 25
Required tools:
• 24 mm open end wrench
• 16 mm open end wrench
•6 mm hex wrench
• Digital level