Scalar i6000 Installation Guide 359
Ethernet Expansion Blade LEDs
The status LEDs for an Ethernet Expansion blade are located at the top of the EEB above ETH 6. Figure
45 shows the locations of the I/O blade Fibre port link LEDs.
Figure 45Location and Colors of Ethernet Expansion Blade Status LEDs
Table 24 Explanations of Ethernet Expansion Blade LED States
Blue Green Amber Description
Off Off Off No power
1 Hz Off Off Powered Down - Ready for removal
Off Off On Booting
Flash 1 Hz Off Normal
Flash 10 Hz Off Normal - Identify
Table 25 Explanations of EEB Ethernet Port LED States
LED Color Possible States and Explanations
Green • Solid on — the link is up; data can be sent or received through the Ethernet port
• Solid off — the link is not up; data cannot be sent or received through the Ethernet port
Amber • Flashes at irregular intervals — data activity is occurring through the Ethernet port
• Solid off — no data activity is occurring through the Ethernet port
EEB LED status
Port LED status
To Next Page
Loading...
