Scalar i6000 Installation Guide 311
Get/Put Test
The Get/Put test performs the following tasks:
• Performs a Get/Put of a scratch tape in the top and bottom slots of each magazine that supports
the scratch tape’s media
• Performs a Get/Put of existing media if no scratch tape is found or if the top or bottom is occupied
• Moves a scratch tape to one row in each frame to test cross-frame alignment
• Uses a scratch tape to perform a Get/Put in each compatible drive
Picker Assembly Test
The picker assembly test performs the following tasks:
• Performs pivot left and right check
• Performs reach and retract five times
• If the LMC gets its side done, performs a Get/Put of the selected cell
• Scans the control module serial number to make sure the scanner is reading properly
I/E Station Assembly Test
The I/E station assembly test performs the following tasks:
• Locks and unlocks I/E station
• Calibrates each I/E station and check offsets collected
• Checks each magazine’s fiducial in the I/E station
• Performs Get/Put tests on all the I/E station cells
Scanner Fiducial Test
The scanner fiducial test performs the following tasks:
• Scans and checks each magazine fiducial
• Scans and checks each drive sled fiducial
• Tests the calibration sensor
• Calibrates and checks repeatability, up to three times for marginal and failed calibration targets
Library Inventory
This inventory list provides the following statistical information:
• Frame card serial numbers
• Power supply serial numbers
• Number of cartridges in the library
• Controller serial number and firmware information for the following:
• Management control blade
• Control management blade
• Robotic control unit or RCU
•Picker
To Next Page
Loading...
