Scalar i6000 Installation Guide 215
9 After you have reviewed the LUN Mapping Change Preview Report, click Close to return to the LUN
Mapping Wizard – Preview All Changes dialog box.
10 If you are satisfied with your LUN mapping changes and want to complete the wizard process, click
Finish. Your LUN mapping changes are finalized, and then you have the option of viewing the LUN
Mapping Report.
Setting up Control Path and Storage Networking
If your library contains LTO-5 drives attached to Ethernet Expansion blades, use the following procedures
to set up your LTO-5 SNW drives.
To use SNW features, you must install an SNW license. See Enabling Licenses
on page 164.
For more information on Control Paths, see Working with Library Control Paths
on page 180.
Configuring Control Path
Use the Control Path function to configure a partition and the appropriate drives to handle the host
application’s control path commands. When you initially create the library partitions, you can configure the
control paths and they are assigned. For more information, see the Scalar i6000 User’s Guide.
Follow the steps below to select a partition and configure the control path for your LTO-5 SNW drive.
1 Log on as an administrator.
2 From the main console, select Setup→ Partitions→ Control Path.
The Storage Networking Partitions dialog box appears.
3 Highlight the partition you want to configure, and click OK.
To Next Page
Loading...
