130 Cabling
7 Connect a SCSI cable to the port of the MCB in the control module.
8 If e-mail notification is going to be used to monitor the library, connect the Ethernet cable that is provided
with the library to the Ethernet port on the MCB in the control module.
9 Route all cable to the right side of the module and either up through one of the three holes in the top or
down through the opening at bottom of the control module. Secure the cable to the right side using the
Velcro straps.
10 Connect the SCSI cables from the drives to the designated hosts.
11 Connect the SCSI cable from the MCB to the server that has been designated to interface with the
library.
12 Connect the Ethernet cable to the internal network.
13 Detach the ESD strap.
To Next Page
Loading...
