Scalar i6000 Installation Guide 199
5 Click a blade to highlight it, and then click Configure.
The FC Port Failover dialog box appears.
6 In the Feature Enable area, select Enable FC Host Port Failover, and then click Set to make the
Configuration tab available.
7 Accept the recovery setting default values unless an authorized representative advises you otherwise.
On the Configuration tab, settings are unavailable if the current state of
the tab is set to Disabled.
Be aware that there might be incompatibilities with channel zoning
configuration on the I/O blade if you enable host port failover. Both target
ports must have the same ports mapped.
To Next Page
Loading...
