Scalar i2000 Installation Guide 239
The Working screen appears. Once the teach is completed, a message appears in the Results field,
for example, “Command Completed.”
28 Add the new drive(s) to a partition using the following procedure:
a. Log into the LMC as service user.
b. Click Setup→ Partitions→ Configure.
The Partitions dialog box is displayed.
c. Select the partition that include the affected magazines and click Modify.
d. Select a partition and add the new drive(s).
29 To avoid confusion, add the affected magazines back into the appropriate partition. The partition should
be the same size as the original partition.
Due to licensing requirements, the physical location of the affected magazines
may not be available until the procedures completes.
To Next Page
Loading...
