Scalar i6000 Installation Guide 343
10 Turn the level around so the display is facing away from you and the screw on the back of the level is
at the bottom. Ensure that the level is positioned in the same spot as Step 7
. Wait 10 seconds for the
level to completely settle. Without moving the level, gently press the HOLD button until an [ 8 ] appears
on the display. If this last step is performed correctly the [ 8 ] will display for a short amount of time and
then the level will display the current angle measurement that it detects. The level is now calibrated and
is ready for use.
To Next Page
Loading...
