RADIOMETER ABL90 FLEX - Page 285

ABL90 FLEX reference manual 10. Troubleshooting, updated for software version 2.3
10-17
No. Message Interpretation Operator action
773 Remote operator
logged on with
user:
A remote operator has
logged on the analyzer via
NetOp.
- No action required.
774 Remote operator
logged off with
user:
An operator, remotely logged
on via NetOp, has logged off,
or has been logged off by a
local operator.
- No action required.
775 Failed to restore
Default Setup
Restoring analyzer setup to
default values has failed.
- Contact Radiometer
service representative.
776 Succeeded to
restore Default
Setup
Restoring setup to default
values is completed.
- No action required.
780 RADIANCE
communication
enabled
RADIANCE communication
has been enabled as part of
the RADIANCE Connection
Setup.
- No action required. For
information only.
781 RADIANCE
communication
disabled
RADIANCE communication
has been disabled as part of
the RADIANCE Connection
Setup.
- No action required. For
information only.
782 RADIANCE
output queue
cleared
The output queue was
cleared in the RADIANCE
Connection Setup.
- No action required. For
information only.
783 Automatic
backup started
Automatic backup (selected
in Disk Functions Setup) has
started.
- No action required. For
information only.
785 Automatic
archiving started
Automatic archiving (selected
in Disk Functions Setup) has
started.
- No action required. For
information only.
786 Automatic
archiving
completed
Automatic archiving (selected
in Disk Functions Setup)
completed successfully.
- No action required. For
information only.
787 Export of data
logs started
Export of data logs was
started by the user.
- No action required. For
information only.
798 User logged on User logged on successfully. - No action required. For
information only.
799 User logged off User logged off. - No action required. For
information only.
800 Logon attempt
failed
User tried to log on but did
not provide a valid password.
- Provide a valid
password to log on.
810 pH locked The parameter has been
locked by a RADIANCE
operator, as reflected in the
Activity Log.
When a parameter is locked,
presumably due to problems
with QC, the parameter is
repressed in patient results.
- Await corrective
actions initiated by the
RADIANCE operator.
Removal condition:
- Determined by the
RADIANCE operator.