Radwin 2000+ SERIES - Page 124

RADWIN2000+SeriesUserManual Release4.2.40 7‐11
Management
Foralinkmanagedaspartofanetwork,directaccessusingTelnetisconsideredtobea
securitybreach.TelnetaccessmaybeenabledordisabledbyclickingtheProtocoltaband
enabling/disablingTelnetaccessusingtheTelnetcheck‐box.Similarconsiderationsapplyto
accessviatheWebInterface.
• ForfurtherdetailsaboutTelnetaccessseeConfiguration withTelnet.
• ForfurtherdetailsabouttheWebInterface,seeUsingtheWebInterface.
TelnetandWebInterfaceaccessmodeswhenavailable,aresitespecific.Ifforexample,you
wantTelnetaccessfromaspecificsite,youshouldenableitforthatsiteanddisableitfor
others .
Conversely,IftheTelnetorWebInterfaceaccessmodesposeageneralsecurityrisk,youmust
disablethemforeachsiteseparately.
MultiuserSupportunderSNMPv3
IfyouchoseSNMPv3orbothversions,youareaskedtologonagain:
Forthefirstlog‐onunderSNMPv3,useaspassword,theUserName,admin.Thereisone
changetothemainwindow.ThetitlebarnowshowstheSNMPv3username: