Radwin 2000+ SERIES - Chapter 21: Using the Web Interface

RADWIN2000+SeriesUserManual Release4.2.40 21‐1
Chapter21:UsingtheWeb
Interface
21.1ScopeofthisChapter
ThischapterdescribeshowtousetheWebInterfacetocarryoutbasiclinkmanagement
tasks.
21.2WhatisitFor
TheWebInterface(WI)enablesyoutocarryoutbasiclinkmanagementfunctionsusinga
Webbrowser.
Itmaybeusedto‐
• Monitoralinkonaminimalbasis
• Checklinkparametersandmakelimitedchanges
• ViewthelinkInventory
• InspecttheRecentEventslogs
21.3WhoNeedsit
TheWIisatoolfortechniciansto“quick‐install”anradiounitinalinkwithminimumeffort.
Itmayalsobeemployedbyauserforaquicklookatcurrentoperatingparametersandthe
RecentEventslogs.
21.4HowitWorks
Assume the link setup, which we used in InitialLinkConfiguration and later.
Onthemanagingcomputer,pointyourbrowserto10.104.4.2andlogonasshownbelow.You
canalsologonovertheairtotheSlaveODUinthesameway .