Radwin 2000+ SERIES - Figure 4-29 Flat; Mounting the IDU-H;HP and RADWIN 2000 I

RADWIN2000+SeriesUserManual Release4.2.40 4‐20
MountingtheIDU‐H/HPandRADWIN2000i
Figure 4‐29showsamountedantenna.Attachthemountingbolttothesideoftheadaptor
withtherecess,asshown.
Figure4‐29:FlatPanelantenna‐mountedtoapole
Groundinganexternalantenna
GroudexternalantennasusingasuitableGroundingKitsuchasanAndrewType223158‐2
(http://www.commscope.com).
4.7.3MountingtheIDU‐H/HPandRADWIN2000i
Indoorunitsareinstalledona19inrack,oronalmostan yotherconvenientlocationlocated
indoors,suchasatable.
MountingtheIDU‐H/HP
TheIDU‐H/HPtakesuphalfofarackwidth.Usethesmallmountingearononeside,andthe
largemountingearontheothersidetomountthisunit(seeFigure 4‐30).AsingleIDU‐H/HP
mountedona19inrackisshowninFigure 4‐31.