Radwin 2000+ SERIES - Chapter 6: Initial Link Configuration

RADWIN2000+SeriesUserManual Release4.2.40 6‐1
Chapter6:InitialLink
Configuration
6.1ScopeofthisChapter
ThischaptercoversthetwophasesofLinkconfiguration:
1. Linkestablishment:Initialsetup
2. Linkmaintenance:Finetuningandspecialfunctions
Linkestablishmentistypicallyaonce‐onlytask.Linkmaintenanceisrequiredforfine‐tuning
thelinkandconfigurationofspecialfeaturessuchasVLAN,QualityofServiceandmore.
6.2LinkEstablishment
6.2.1LinkConfigurationWorkflow
Assoonpowerandnetworkconnectionsaresuppliedtotheradiounit,itwillcommence
transmittingandreceivingpack etsrelatedtomanagementonly‐thatis,noservicetrafficwill 
besentorreceived.
Activation:FortheRT‐A(HBS)tocarryoutservice,itmustbeactivated.Activationand
Deactivationareeffectedquitesimplybyclickingatogglebutton.
Discovery:AssumingthattheradiounitintendedastheRT‐B(HSU)(SlaveODU)ismounted,
aligned,andpoweredup,itwilldiscovertheRT‐A(HBS)establishingalinkfor
managementonly.AtthispointtheRT‐B(HSU)maybemanagedovertheair.
Registration:Ha
vingIdentifiedtheLinkRT‐B(HSU),thelattermustberegisteredtotheRT‐
A(HBS)toenabletrafficbetweenthem.
Followingregistration,youcansetseparately,
• MIMOmode
• Transmissionratiobetweenuplinkanddownlink
• UplinkanddownlinkMaximumInformationRate(MIR)inMbps