Radwin 2000+ SERIES - Configuring GHSS with an Internal GPS Unit

RADWIN2000+SeriesUserManual Release4.2.40 12‐10
ConfiguringGHSSwithanInternalGPSUnit
12.4.3ConfiguringGHSSwithanInternalGPSUnit
WithGHSS,allbasestations(RT‐A(HBS)units)areHSSClients,withtheGPSsatellitesignal
beingthemaster.RT‐B(HSU)unitsarealwaysindependentunits(INU).
1. LogontotheRT‐A(HBS).
2. OpentheConfigure|HubSiteSynctab:
Figure12‐6:
HSSSettingswindow‐GHSS
3. CheckEnabled.ThebottompartofthewindowinFigure 12‐6isenabled(youwill
soonchangetheProtocolfromEthernettoGPS).