Radwin 2000+ SERIES - Log-On with Local Connection; Other Log-On Options

RADWIN2000+SeriesUserManual Release4.2.40 5‐5
Log‐OnwithLocalConnection
5.3.3Log‐OnwithLocalConnection
Alternatively,youcanlogonusingLocalConnection(Figure 5‐2)withouthavingtochange
yourNetworkInterfaceCardaddress.
5.4OtherLog‐onOptions
SNMPv3: RADWIN2000+SeriessupportsSNMPv1andSNMPv3eitherseparatelyor
together.Thelog‐onprocedurediff ersslightlybetweenoperationunder
SNMPv1andSNMPv3.Table 5‐2showsthedifferencebetweenSNMPv1and
SNMPv3atlog‐ontime.
UserTypes: TheRADWINManagerprovides threelevelsofaccessinoneoftwoentry
modes.Toseethem,clickOptionsatanytimeintheLogonwindow(Figure 5‐
2above).Youareofferedanextendedlog‐onwindow:
• TheLocalConnectionmethodusesbroadcastpacketsto“discover”
theattachedradiounit.
• IfyoulogonusingLocalConnection,butyourphysicalconnectionis
notlocal,thenanyconfigurationyoucarryoutmayaffectotherlinks
inthenetwork.Donotdothis!
• Donotcarryoutthisprocedureusingamultihomedmanagingcom‐
puteralsoconnectedtoanetwork.Itwillfloodthenetworkwith
broadcastpack ets.Further,itwillthrowanyotherlinksonthenet‐
workintoInstallationorInactivemode.
• Asaprecaution,defaultlog‐onoverLocalConnectionisread‐only
mode.ChecktheRead/Writeenableboxtocarryoutinstallationpro‐
cedures.
•Networklogon(IPaddresstotheradiounit)isrecommended.