Radwin 2000+ SERIES - Figure 4-43 Connections: Hss over Ethernet Using the Idu-H;Hp; GPS Hub Site Synchronization with an External GSU

RADWIN2000+SeriesUserManual Release4.2.40 4‐30
GPSHubSiteSynchronizationwithanexternalGSU

Figure4‐43:Connections:HSSoverEthernetusingtheIDU‐H/HP
ItispossibletosynchronizethebasestationsofanyRADWINradioproductco‐locatedwitha
RADWIN2000+SeriesMasterODU.
4.9.3GPSHubSiteSynchronizationwithanexternalGSU
IfyouwishtouseaGPSsignaltocarryouthubsitesynchronization,andtheunityouare
workingwithdoesnothav eanintegrated/internalGPScapability,youcanusetheRADWIN
GSU.ThisdeviceconnectstotheIDU‐H/HPontheoneside,andtotheGPSsatelliteonthe
other,viaaGPSantenna.TheIDU‐H/HPinturn,connectstothevariousco‐locatedbase
stations,asshown:
ItispossibletouseHSSoverEthernetwitha3rd‐partyL2switchinsteadofthe
IDU‐H/HP.Ifyoudoso,makesuretheL2switchfulfillstheseconditions:
‐MustsupportGbE
‐DoesnotsupportEEE(EnergyEfficientEthernet),or
‐IfitsupportsEEE,itshouldbeaccordingtotheIEEE802.3azstandard