Radwin 2000+ SERIES - Configuring the RT-A(HBS) as an HSS Client

RADWIN2000+SeriesUserManual Release4.2.40 11‐9
ConfiguringtheRT‐A(HBS)asanHSSclient
NoticeadditionalHSSclientatIPaddress10.104.3.2:Itiscollocatedtotheforego‐
ingradiosusinganHSSunitconnectedtotheHBS.
11.4.3ConfiguringtheRT‐A(HBS)asanHSSclient
WeswitchHSSrolesbetweenourRT‐A(HBS)andthecollocatedODU.
 ToconfiguretheRT‐A(HBS)asanHSSoEClient:
1. Followsteps1to4forconfiguringtheHSSmaster(seeConfiguringtheRT‐A(HBS)as
anHSSmasteronpage 11‐4).
2. A tstep5forHSSmaster,chooseHubSyncClient‐ContinueTx.
Hereistheoutcome: