Radwin 2000+ SERIES - Throughput Checking

RADWIN2000+SeriesUserManual Release4.2.40 8‐3
ThroughputChecking
ThecontentoftheDiagnosticsreportisanaggregateofallthemorespecificreports
discussedbelow.ItisprimarilyintendedforusebyRADWINCustomerService.
8.2ThroughputChecking
Inthismode,RADWIN2000+SeriesestimatesEthernetthroughputbyfillingframesoverthe
airtomaximumfor30seconds.Thismodeshouldnotinfluenceservice.
 TouseThroughputChecking:
1. ChoseEstimatedThroughputfromtheToolstab:
TheSpectrumAnalysisoutputisavailabledirectlyfromtheSpectrum
ViewutilityasaCSVfile(seeSpectrumView).Theformatinthe
DiagnosticsreportisintendedforusebyRADWINCustomerService.
TheSpectrumAnalysissectionoftheDiagnosticsreportisbasedonthe
lastavailablespectrumanalysis(ifany).Ifyouaresubmittingasupport
requestinvolvinginterferenceissues,orifyouarespecificallyaskedby
CustomerServicetosubmitaDiagnosticsreportcontainingarecent
spectrumanalysis,youshouldcarryouttheanalysisinaccordancewith
theSpectrumViewinstructionspriortousingtheGetDiagnosticsfacility.