Radwin 2000+ SERIES - Figure 8-1 Get Diagnostics

RADWIN2000+SeriesUserManual Release4.2.40 8‐2
RetrievingLinkInformation
 Togetdiagnostics:
1. ClicktheGetDiagnosticsbutton:
Figure8‐1:GetDiagnosticswindow
2. Selectordeselectthedataoptions.IfthefileistobesenttoRADWINCustomer
Serviceleavealloptionschecked.
3. ClickFilePathtospecifythefilenameandolderinwhichyouwanttosavethefile
andthenclickRuntosavetheinformation.
Oncompletion,thestatusofthecheckeditemsisconfirmed:
LinkInformation InformationabouttheRT‐A(HBS)andRT‐B(HSU)settings
SiteConfiguration Dataaboutthesiteparameters
Monitor Detailedeventdatarecord
ActiveAlarms ActiveAlarmsareraisedforanyeventaffectingavailabilityor
ServiceConfiguration Settings:MIMO,TxRatio,MIR,VLAN,QoS
PerformanceMonitor Networkperformancedataoverdefinedtimeperiods‐‐every15
SpectrumAnalysis ForRT‐A(HBS),selectedRT‐B(HSU)sandgeneralinterference
Table8‐1:GetDiagnosticsDataandDescription(Continued)
Data Description