Radwin 2000+ SERIES - Figure 5-1 Pinging the Base; First Log-On

RADWIN2000+SeriesUserManual Release4.2.40 5‐3
FirstLog‐on
3. Checkthatyouhaveconnectivitytotheradiounit.Youcandothisbyopeningupa
commandlinesession(Start|Runandthentype,cmd).Atthecommandprompt,
type
ping10.0.0.120
Youshouldseeadispla ysimilartothis:
Figure5‐1:Pingingthebasestation.
Anyotherresponsefrompingmeansthattheradiounitisnotresponding.Check
yourEthernetconnectionandthatthePoEisswitchedon(orvoltageisconnected
totheradiounit)andthentryagain.Ifyoudonotsucceed,seekassistancefrom
RADWINCustomerService.
4. Dismissthecommandlinesession.
5.3.2FirstLog‐on
1. OpentheRADWINManagerfromthedesktopicon,orclickStart|Pr ograms|RAD‐
WINManager|RADWINManager.
TheLog‐ondialogboxappears: