Radwin 2000+ SERIES - Figure 14-1 Bulk Backup Setup; Figure 14-2 Add; Remove Site

RADWIN2000+SeriesUserManual Release4.2.40 14‐2
BulkSoftwareBackup
Thefollowingdetachedwindowappears:
Figure14‐1:BulkBackupsetupwindow
ThedefaultsitesshownintheBulkBackuplistpanelbelongtothecurrently
installedlink.ThelistmaybeemptyifyouarerunningtheRADWINManager
“offline”.
2. TheBulkBackuplisttitlebarhasthreebuttonsontherighthandside.
Figure14‐2:Add/Removesitebuttons
TheleftbuttonopensupaWindowsfiledialogtolocatealistoflocationsto
backup.ThelisthasthefollowingformatforSNMPv1:
<IPaddress>,<Read‐Onlycommunity>,<Read‐Writecommunity>
ForSNMPv3itis:
<IPaddress>,<Dummy>,<User_type><Password>
Forexample:
10.104.3.2,netman,admin,netwireless