Radwin 2000+ SERIES - Deactivate RT-A(HBS); Deregister RT-B(HSU); Reset the ODU; Suspend a Deregistered RT-B(HSU)

RADWIN2000+SeriesUserManual Release4.2.40 7‐28
DeactivateRT‐A(HBS)
Auto‐ Buzzerrespondsaccordingtosignalstrength.Thisisthesettingusedforantenna
alignment.FordetailsseeAntennaAlignmentonpage 4‐39
AdvancedAuto‐Buzzeronwhilelinkdown,remainsonforanex tratwominutes.
Refresh
TheRefreshbuttonrestoresthecurrentwindowtoitspreviousstateabandoninganychanges
youmade,providedthatyoudidnotclickApplyorOK.
7.5DeactivateRT‐A(HBS)
DeactivatingtheRT‐A(HBS)haltstrafficoverthe linkanddropsitbacktothedefault
transmissionmodepriortoconfigurationwithoneexception:TheRT‐B(HSU)remains
“registered”butinaccessibleovertheair.YoucanreactivatetheRT‐A(HBS)withoutneedto
re‐registertheRT‐B(HSU).AlloftheRT‐B(HSU)configurationsettingsarepreserved.
7.6DeregisterRT‐B(HSU)
DeregisteringtheRT‐B(HSU)stopslinktrafficsbutleavesitaccessibleovertheairfromtheRT‐
A(HBS).AlloftheRT‐B(HSU)toolbarfunctionsareavailable.
7.7SuspendaDeregisteredRT‐B(HSU)
Youmaybreakthelink(causeafullsyncloss)tothederegisteredRT‐B(HSU)forafixed
amountoftime.
7.8ResettheODU
TheresetfunctionsareequivalenttopoweringtheODUdownandthenpoweringitupagain.