Radwin 2000+ SERIES - Page 188

RADWIN2000+SeriesUserManual Release4.2.40 12‐11
ConfiguringGHSSwithanInternalGPSUnit
4. BeforeyoucanchangetheProtocolfromEthernettoGPS,youmustfirstchoosethe
OperationalStateasHubSyncClient‐ContinueTxorHubSyncClient‐DisableTx,
accordingtoyourpreference.
•HSSClient‐ContinueTransmission(HSC‐CT):Iftheunitlosessynchronizationwith
theHSSMaster,thelinkremainsactive.However,withoutsynchronizationpulses,
itispossiblethatthisunitwi ll causeinterference.
•HSSClient‐DisableTransmission(HSC‐DT):Iftheunitlosessynchronizationwith
theHSSMaster,thelinkisdroppeduntilthesynchronizationpulsesre sume.This
settingpreventstheunitfromcausinginterference.