Ricoh LDD280 - 3.7 MASTER FEED SECTION

MASTER FEED SECTION
C262/C265 3-28 SM
3.7 MASTER FEED SECTION
3.7.1 MASTER MAKING UNIT
CAUTION: When you remove the master making unit from the main frame, make
sure to disconnect the two connectors [A].
• Drum unit ( 3.8.1)
1. Pull out the master making unit [B]. Make sure that the distance between the
main frame and the edge of the master making unit is 110 mm or less. If you
pull the unit out more than 110 mm, you cannot do step 4.
2. Remove the connector cover [C].
3. Remove the two connectors [A].
4. Check that the hook on the flat cable [D] is attached to notch [E] in the master
feed control roller bracket.
NOTE: This hook must always be attached when you install the master making
unit, to prevent damage to the cable.
C262R170.WMF
110 mm
110 mm
[A]
[B]
[C]
[D]
[E]